Revelin

A plant growth regulator for the control of sucker growth on Burley, Cigar, Dark, Flue-cured, and Maryland tobacco.

Features and Benefits

  • Contains 1.2 pounds of Flumetralin per gallon.
  • Can be used in coarse spray applications or as run down application.
  • Can be integrated into a systemic portion of your sucker control program.
  • Rainfast within 2 hours of application.
  • Approved for split application and can provide improved sucker control when done so. (See label for details.)
  • No plant back restrictions when used at labeled rates (do not allow excessive runoff onto the soil).

Application

  • Apply this product when most tobacco plants are in the elongated button to early flower stage, either before or after topping. If this product is applied after topping, apply within 24 hours of topping and remove all suckers one inch or greater from all plants. 
  • Mix 3 to 4 quarts of this product in sufficient water totaling a minimum of 50 gallons of water and apply a minimum of 50 gallons of spray volume per acre. Spray volume should be sufficient to run down the stalk, contacting all leaf axil and sucker buds. Excessive spray volume beyond the point of runoff to the soil may result in carryover injury to rotational crops. Do not exceed 1 gallon of this product (1.2 lbs. of Flumetralin) per acre. 

  • One application of this product at the 1 gallon per acre rate will provide control of excessive tobacco sucker development. Read label carefully and observe all directions and precautions.

  • The diluted emulsion is most easily prepared by adding the required amount of this product into the spray tank one-half filled with water using mild agitation. Then add sufficient water to the spray tank to total the required minimum solution as specified in the “METHODS OF APPLICATION” section of the label. 

Resources

Spectrum Label

Product Label

Safety Data

Safety Data Sheet

Product Info

Features & Benefits

Product Info

Tobacco Program